* For conveyor widths 75, 100, 150, 200 and 250 mm,
custom profiles are used
35
2
The combination of standard parts based
on the profile mk 2000 results in a conveyor
system
that allows for the widest possible
range of drives and tails and extremely
short delivery times. Despite its low height
of 50 mm and the ø 53 mm driving roll,
which can be coated with rubber according
to the application, the conveyor offers a
wide range of different belt types. As with
all mk belt conveyor systems, the crowned
roller of the driving and idler rollers make
belt adjustment significantly easier.
T-slots running along both sides (10 mm
slot width based on our profile technology)
allow you to easily integrate the conveyors
into existing machine frames or attach
stands, side rails and other accessories.
A further quality feature of this conveyor
system is the stainless steel sheet installed
below where the belt runs, which ensures
long-term wear resistance of the belt. In
addition to our wide selection of side rails
and stands, we also offer a standard range
of end stops and electrical
accessories.
Benefits of the
GUF-P 2000
Wide range of different drives, tails,
stands and belt types
Built with the profile mk 2000 for a high
load capacity and torsion-resistant
structure
Optionally available with a stationary
or rolling knife edge
Flexible operation in reverse, accumulated
Very short delivery times
Profile mk 2000*
Profile mk 2000*
and cycling mode
Cross Section
Belt Conveyors
B ≙ conveyor width