Detail A è Page 119 Detail B è Page 265
The parallel clamping connector connects profiles
in parallel without additional machining. The connector
is inserted into the two opposite-facing slots
and tightened using an Allen key.
The lock is designed for installation in the mk 2040.01
and mk 2040.40 profiles. This requires profile services
5401BC or 5440BC. Both the total length of the profile
and the distance from the bottom end of the profile
to the bottom edge of the lock must be specified. To
install the lock, the profile cylinder is pressed through
the profile opening into the swivel bolt and then secured
using a screw and nut connection.
Detail C è Page 190 Detail D è Page 259
Fixed and swivel casters
K106001041 and K106000141
The casters are attached in the centre of the foot
plate that matches the profile (foot plate I M10 in
this case) using an M10 hexagon head screw. The
casters have a load capacity of 600 N. The swivel
casters have a locking device.
50.02.0041 foot plate I M10
The hinge is mounted between two profiles using
countersunk head screws and nuts that fit the particular
profiles series. The fastening accessories
you need are included in the set. The keys on the
hinge leaves ensure that the components are parallel.
The use of three hinge leaves means that the
door cannot be unhinged and removed without
removing the hinge.