353
11
Detail A
Detail B
Protective Device Guard with Sliding Doors
A machine housing was built for a manual lathe. The shape and appearance of the guarding needed to be
adapted to the lathe. The housing was completely closed off using sheet panels to prevent chips and drilling
fluid from getting into the production hall. Two separately controlled sliding doors allow easy access and
operation of the machine. The sliding doors are electrically driven using timing belts.
Detail A è Page 119 Detail B è Page 171
Swivel clamp connector
B51.03.011
Hinge tension plugs allow the connection of mitrecut
Series 40 profiles. All connection angles from
0° to 90° are possible. The connection requires a
single-sided ø 10 mm bore in both profiles on the
chamfered side, 15 mm from the centre of the cut
edge.
Levelling foot KB M12
B67.02.001
The levelling foot is screwed into the foot plate that
matches the profile, in this case foot plate I M12
(50.02.0035). Once the height is adjusted, the foot
is locked using the nut on the foot plate. The levelling
foot has an adjustment range of 75 mm and a
load capacity of 1,500 N. The ball joint allows for
compensation of slanted surfaces.
Application Examples